About the Journal
ABOUT RESISTOR JOURNAL
RESISTOR Journal is a journal published by the Institute for Research and Community Service (LPPM) STMIK STIKOM Indonesia, with P-ISSN 2598-7542 and E-ISSN 2598-9650. The RESISTOR journal is first published in October 2017 and has a publishing period twice in a year, namely in April and October. All articles in the RESISTOR Journal will be processed by the editor through the Online Journal System (OJS), and the author can monitor the entire process in the member area. Articles published in RESISTOR Journal, both in hard and soft copy, are available as open access for educational, research and library purposes, and beyond that purpose, the editorial board of RESISTOR Journal is not responsible for copyright infringement.
The diversity of branches of science in computer technology certainly requires a forum to accommodate studies and research that emerge from these disciplines. STMIK STIKOM Indonesia currently has a Computer Systems or Computer Systems Engineering department in English called Computer System Engineering. This discipline is of course related to the process called engineering. Engineering is the application of science and technology to solve human problems. In this case computer system engineering, involves hardware and software to solve problems faced around. Surely, by focusing on specific scope, making the quality of research better and directed.
Selection of the word Resistor as the name of the journal is the result of discussions with computer system lecturers. As we know that resistors are one of the important electronic components in regulating and dividing electric current. As electricity is divided, such research results must also be shared and published to get input feedback and further increase the diversity of research that leads to improving the quality of the results of the computer system products being produced.
Based on a very high desire to improve the quality of research works by students and lecturers, the STMIK STIKOM Indonesia Computer System Study Program publishes a journal with the name of the Journal of Computer System Engineering or RESISTOR. The first publication of this journal was on April 21, 2018, took the momentum of Kartini's day, which the most well-known note, that is, From Darkness to Light. Hopefully this journal can contribute continuously in increasing the development of science and technology.
OPEN ACCESS POLICY
The author's copyright in the RESISTOR (Rekayasa Sistem Komputer) Journal, assigns that the publication of published articles is owned by the editorial board with the author's approval, but the rights are still with the author. The legal rules for accessing digital electronic articles are under license Attribution-NonCommercial-ShareAlike 4.0 International (CC BY-NC-SA 4.0), which means that the RESISTOR Journal has the right to store, modify, manage databases, maintain and publish articles without the author's permission, but the author as the copyright holder is still written as it is. Articles published in RESISTOR Journals, both in hard and soft copy forms are available as open access, for educational, research and library purposes, and beyond that purpose, the editorial board of the Language and Language Journal is not responsible for illegal copyright infringement. This journal also applies LOCKSS and CLOKSS archiving.
Author(s) who publish article in RESISTOR (Rekayasa Sistem Komputer) Journal, agree to the following terms:
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under license Attribution-NonCommercial-ShareAlike 4.0 International (CC BY-NC-SA 4.0) that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work.
PEER REVIEW PROCESS
The article that has been sent to RESISTOR Journal will be through two review process namely pre-review and review. Pre-review process of the article is done by managing director that include:
- Focus and Scope: The article being sent should in accordance with the scope of RESISTOR Journal, focus and scope can be seen here. The article outside the scope of RESISTOR Journal will be rejected.
- Plagiarism Check: Plagiarism check and article similarity are done by using google schoolar and itenthicate with maximum score 15%. Article that has similarity check above 15% will be returned to the writer for revision.
- References: references used in the article are minimum 10 references that consist of 80% primary sources and 20% secondary sources. References use IEEE style and made by using references managing software like Mendeley.
- Template: the submitted article should in accordance with the template in RESISTOR Journal which can be seen and downloaded here.
If from the four components, there is something not in accordance, then the article will be returned to the writer to be revised. Writer is given time for seven days to revise the article and send it back.
When the four components in the review process are fulfilled, then the article will be continued to be reviewed by the reviewer through editor. The substances review process is done by two reviewer in Double Blind Peer Review. Reviewer can give recommendation such as:
- Accept Submission: article is accepted to be published without having revision in substances.
- Revision Required: the article with minor revision, article is sent to the writer to be revised (when the writer has sent the revision, article can be accepted to be published)
- Resubmit for Review: the article with major revision. After revision is done by the writer, article is resubmitted to the reviewer to be reviewed again ( maximum three times resubmit), If the article is not quite right in substance after the fourth review, then reviewer is allowed to give recommendation as Decline Submission.
- Resubmit Elsewhere : in substance, article is considered as less suitable and suggested to be submitted into other journal
- Decline Submission: article is rejected by the reviewer to be reviewed with two reasons, (1) reviewer rejects because of a reason (not related to articleâ€™s substances), then the article is sent to another reviewer. (2) rejected article in substance is considered less suitable to be published in journal.
ARTICLE PROCESSING TIME ON RESISTOR JOURNAL
Pre-review process takes time about 3-7 days
Writer has 1 week to revise the article in pre-review stage. Writer who has not revised the article at that time and without giving any statement, then the managing director has done meaningless work, then the article will be rejected.
Review process by the reviewer is done about 2 weeks every round. The numbers of round in review process depends on the reviewer recommendations.
Writer is given one week to revise the article from reviewer, and if the writer does not send the revision at the specified time without any statement, then editor and reviewer has done meaningless work, then the article is rejected.
The duration of the article starts from the submitting until production stage in detail can be seen in the image below.
LOA (LETTER OF ACCEPTANCE)
LOA on RESISTOR Journal consists of 2 types, those are LOA that will be sent through the writerâ€™s email automatically by OJS when the article has been accepted to be published.
Second LOA is manual LOA that will be attached on the discussion section on OJS when the article has been accepted to be published.
LOA will only be given to the writer when the article has entered production stage.
Manuscript rejection or manuscript cancellation on RESISTOR Journal consists of two types, namely rejection or withdrawal without fine, and rejection or withdrawal with fine. Withdrawal without fine happens because of three things, those are:
- Do not in accordance with the focus and scope.
- Writer do not revise the article both in pre-review and review stage along the specified tine without any reason.
- Article rejection by recommendation of the reviewer related to substances/content of the article
Rejection or withdrawal with fine happens because of two things, those are:
- Writer that takes his writing with any reasons when the article has been proceed (enter the pre-review stage by the managing director).
- There is duplication in publication, where the writer do submitting article in several journal and one of them is RESISTOR Journal, or the article has been published in another journal and re-submit on RESISTOR Journal.
Article withdrawal after being proceed or duplication in publication is a wasting time where managing director, editor and reviewer has done a meaningless activity so in this case the writer is fined about Rp. 1.000.000,- Cancellation will be done when the writer has done the payment and sent the receipt of payment to the editor of RESISTOR journal. If the writer does not agree to pay the fine, then the writer will be put into blacklist with the consequences; the writer will be blacklisted from RESISTOR Journal, so the writer could not submit the article.
PUBLICATION ETHICS AND MALPRACTICE STATEMENT
These guidelines are fully suitable with the COPE Principles of Transparency and Best Practice Guidelines and the COPE Code of Conduct. For more details can be seen in the following link: https://publicationethics.org
Section A: Publication and authorship
- All submitted papers are subject to strict peer-review process by at least two international reviewers that are experts in the area of the particular paper.
- Review process are blind peer review.
- The factors that are taken into account in review are relevance, soundness, significance, originality, readability and language.
- The possible decisions include acceptance, acceptance with revisions, or rejection.
- If authors are encouraged to revise and resubmit a submission, there is no guarantee that the revised submission will be accepted.
- Rejected articles will not be re-reviewed.
- The paper acceptance is constrained by such legal requirements as shall then be in force regarding libel, copyright infringement and plagiarism.
- No research can be included in more than one publication.
Section B: Authorsâ€™ responsibilities
- Authors must certify that their manuscripts are their original work.
- Authors must certify that the manuscript has not previously been published elsewhere.
- Authors must certify that the manuscript is not currently being considered for publication elsewhere.
- Authors must participate in the peer review process.
- Authors are obliged to provide retractions or corrections of mistakes.
- All Authors mentioned in the paper must have significantly contributed to the research.
- Authors must state that all data in the paper are real and authentic.
- Authors must notify the Editors of any conflicts of interest.
- Authors must identify all sources used in the creation of their manuscript.
- Authors must report any errors they discover in their published paper to the Editors.
Section C: Reviewersâ€™ responsibilities
- Reviewers should keep all information regarding papers confidential and treat them as privileged information.
- Reviews should be conducted objectively, with no personal criticism of the author
- Reviewers should express their views clearly with supporting arguments
- Reviewers should identify relevant published work that has not been cited by the authors.
- Reviewers should also call to the Editor in Chiefâ€™s attention any substantial similarity or overlap between the manuscript under consideration and any other published paper of which they have personal knowledge.
- Reviewers should not review manuscripts in which they have conflicts of interest resulting from competitive, collaborative, or other relationships or connections with any of the authors, companies, or institutions connected to the papers.
Section D: Editorsâ€™ responsibilities
- Editors have complete responsibility and authority to reject/accept an article.
- Editors are responsible for the contents and overall quality of the publication.
- Editors should always consider the needs of the authors and the readers when attempting to improve the publication.
- Editors should guarantee the quality of the papers and the integrity of the academic record.
- Editors should publish errata pages or make corrections when needed.
- Editors should have a clear picture of a researchâ€™s funding sources.
- Editors should base their decisions solely one the papersâ€™ importance, originality, clarity and relevance to publicationâ€™s scope.
- Editors should not reverse their decisions nor overturn the ones of previous editors without serious reason.
- Editors should preserve the anonymity of reviewers.
- Editors should ensure that all research material they publish conforms to internationally accepted ethical guidelines.
- Editors should only accept a paper when reasonably certain.
- Editors should act if they suspect misconduct, whether a paper is published or unpublished, and make all reasonable attempts to persist in obtaining a resolution to the problem.
- Editors should not reject papers based on suspicions, they should have proof of misconduct.
- Editors should not allow any conflicts of interest between staff, authors, reviewers and board members.